Miller S-22P12 Manual Del Operador página 23

NOTE
Wire Diameter
Fraction Decimal
.023/.025 in .023/.025 in
.030 in .030 in
.035 in .035 in
.040 in .040 in
.045 in .045 in
.052 in .052 in
1/16 in .062 in
.035 in .035 in
.045 in .045 in
.052 in .052 in
1/16 in .062 in
5/64 in .079 in
.035 in .035 in
.045 in .045 in
.052 in .052 in
1/16 in .062 in
.068-.072 in .068-.072 in
5/64 in .079 in
.045 in .045 in
.052 in .052 in
1/16 in .062 in
5/64 in .079 in
Table 7-1. Drive Roll And Wire Guide Kits
Base selection of drive rolls upon the following recommended usages:
1. V-Grooved rolls for hard wire.
2. U-Grooved rolls for soft and soft shelled cored wires.
3. U-Cogged rolls for extremely soft shelled wires (usually hard surfacing types).
4. V-Knurled rolls for hard shelled cored wires.
5. Drive roll types may be mixed to suit particular requirements (example:
V-Knurled roll in combination with U-Grooved).
Kit No.
Metric
0.6 mm 087 131
0.8 mm 079 594
0.9 mm 079 595
1.0 mm 161 189
1.2 mm 079 596
1.3 mm 079 597
1.6 mm 079 598
0.9 mm 044 749
1.2 mm 079 599
1.3 mm 079 600
1.6 mm 079 601
2.0 mm 079 602
0.9 mm 079 606
1.2 mm 079 607
1.3 mm 079 608
1.6 mm 079 609
1.8 mm 089 984
2.0 mm 079 610
1.2 mm 083 318
1.3 mm 083 317
1.6 mm 079 614
2.0 mm 079 615
Drive Roll
Part No. Type
087 130 V-Grooved
053 695 V-Grooved
053 700 V-Grooved
053 696 V-Grooved
053 697 V-Grooved
053 698 V-Grooved
053 699 V-Grooved
072 000 U-Grooved
053 701 U-Grooved
053 702 U-Grooved
053 706 U-Grooved
053 704 U-Grooved
132 958 V-Knurled
132 957 V-Knurled
132 956 V-Knurled
132 955 V-Knurled
132 959 V-Knurled
132 960 V-Knurled
083 489 U-Cogged
083 490 U-Cogged
053 708 U-Cogged
053 710 U-Cogged
Inlet
Wire Guide
056 192
056 192
056 192
056 192
056 193
056 193
056 195
056 192
056 193
056 193
056 195
056 195
056 192
056 193
056 193
056 195
056 195
056 195
056 193
056 193
056 195
056 195
S-0157-C
OM-1569 Página 19