Carlson Pet Products 0460 El Manual Del Propietario página 7

Assembling and Installing Your Gate
NOTE: You will notice a slight gap between the gate door latch and the frame. This is not a
defect. Your gate is a pressure mounted gate and this gap will disappear once you tighten
your gate in its opening.
STEP 1
Locate the (4) threaded spindle rods.
Rotate the adjustment wheels along
the threading, eliminating the gap
between the adjustment wheel and the
rubber foot.
ADJUSTMENT WHEEL
RUBBER FOOT
STEP 2
Insert the (4) threaded spindle rods
into the holes at each of the four
corners of the gate.
NOTE: The ends of the gate frame are not threaded. The threaded spindle rods should slide
into the end of the frame tubes without any resistance.
ENGLISH
7