Troubleshooting; Setup Troubleshooting - Lexmark 310 Serie Guía De Usuario

Setup troubleshooting

Symptom
Incorrect language
appears on the
display
The Power light is
not lit
Alignment page or
test page will not
print
Diagnosis
Did you select the wrong
language during the initial
printer setup?
Is the power supply pushed
all the way into the printer?
Is the printer connected to a
working electrical outlet?
Is the printer on?
Do you see an error
message?
Did you remove the
transparent tape from the
bottom of the print
cartridge?
Is the print cartridge
installed properly?
Is the photo paper loaded
correctly?
37
Solution
See "Changing the control
panel display language" on
page 23.
1 Disconnect the power
supply cord from the wall
outlet, and then from the
printer.
2 Reconnect the power
supply cord by pushing it
all the way into the wall
outlet and the connector
on the printer.
3 Press the Power button.
1 Connect the printer to an
electrical outlet that other
electrical devices have
been using.
2 Press the Power button.
Press the Power button. If
the Power light does not
come on, see "The Power
light is not lit" on page 37.
See "Error messages
troubleshooting" on page 45.
Remove the print cartridge,
check for the transparent
tape and then reinsert it.
See "Replacing the print
cartridge" on page 31.
See "Loading the photo
paper" on page 10.