Kohler 5714-VBW-0 Guia De Instalacion página 12

User Interface Cable
Inter-
Connect
Cable
Heated
Chromatherapy
Surface
Cable (If Equipped)
Control
Transducer Wires
4. Route the Cables
IMPORTANT! Several of the included bath components will be powered by the control amplifier via 25'
(7.6 m) cables. Plan the location of the control amplifier so the cables will reach without being under
tension.
Connect the Cables at the Heated Surface Control
NOTE: The heated surface control is mounted to the control board at the end of the bath.
Connect the larger Ethernet end of the user interface cable to one of the two ports on the heated
surface control.
Connect the inter-connect cable (both ends are Ethernet) from the control amplifier to the open port
on the heated surface control.
Route the Cables Through the Framing
Carefully cut the cable tie securing the coiled transducer wires to the bath.
Route the transducer wires through the framing to the control amplifier location, drilling 1" (52 mm)
holes where needed.
If equipped, route the chromatherapy cable from the bath to the planned amplifier location.
Route the transducer wires from the bath to the planned control amplifier location.
Route the inter-connect cable from the heated surface control to the control amplifier location.
Include a drip loop.
Route the user interface cable through the framing from the heated surface control to the planned
user interface location. Include a drip loop.
NOTE: If used, route an auxiliary-in cable (not included) to the control amplifier location.
1297610-2-B
User Interface Cable
Inter-Connect Cable
Drip Loop
User Interface
Heated
Surface
Control
Control Board
12 Kohler Co.