Put the front post into the
decorative part (6) first,
then connect the console
bottom wire (21) with middle
console wire (66). Please
do it carefully, following the
assembly photo. Fix the
front post on the main frame
with two sets of screws (18)
and waved washer (20) and
two sets of screws (18) and
flat washers(17) properly.
Then fix the decorative
part(6) into the plastic cover.
Put the two wires on the handle bar into the hole on the front post (7) and
pull it out. Fix the left handle bar (48) with two sets of screws (18) and
washers (65) properly and tighten it by spanner. Then do the right handle
bar (62) in the same way.
3
4
EN
33