Associated 6009 Manual Del Operador página 4

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATING INSTRUCTIONS
CAUTION:
This battery charger must be fully assembled before operating. Failure to do so may result in risk of injury.
USE OF THE INSTRUMENT PANEL:
The MINUTES CHARGE timer has an OFF position, a CONTINUOUS CHARGE position and a timed charge range from 0 to 120 minutes.
OFF - Always make sure the timer is in the OFF position before connecting or disconnecting the clamps from the battery. The charger will not
a.
charge with the timer in this position.
0 to 120 MINUTES TIMED CHARGE - The timer will automatically turn the charger off at the end of the pre-set charging time. Turn the timer
b.
past 20 before setting the desired time.
CONTINUOUS CHARGE - The timer will not shut the charger OFF while in this position. Extended Charging can be done if the operator is
c.
knowledgeable in determining the proper rate and length of charge and monitors the charging process to prevent overcharging.
TO CHARGE BATTERIES
Make the connections to the battery per the instructions in the previous sections. Determine if the battery is 6 or 12 volts and then set the CHARGE
VOLTAGE switch to 6/12 LOW CHARGE for a 6 or 12 volt battery. If higher rate is desired, set at 12 MED. or 12 HIGH. DO NOT charge a 6 volt
battery at setting other than 6/12 low.(Damage may occur to the battery.) Turn the timer on and the Ammeter will show the amount of current
delivered to the battery. Length of charge should be per the above chart and instructions.
12 VOLT CRANKING ASSIST
1.
Turn off all lights and accessories in the stalled vehicle.
2.
Connect the charger to battery per previous instructions.
3.
Charge the battery on 12HI for at least five minutes before attempting to start the vehicle.
4.
Start the vehicle with the charger connected to the battery. Follow the duty cycle on the unit.
NOTE: Do not crank the engine more than 20 seconds in any five minute period; excessive cranking may overheat and damage the starter.
If the vehicle fails to start, while waiting for the starter to cool, allow the charger to continue to charge the battery. Turn the switch to OFF and
remove the AC power cord from the electric outlet before disconnecting the DC clamps.
CHARGING SULFATED BATTERIES
If your battery has sat in the discharged state for an extended period of time, it can become SULFATED. This usually is seen as a white deposit
near the top of the battery. The sulfate is formed when a battery with low water levels remains discharged for an extended time. Sulfated batteries
exhibit the characteristic of accepting no charge regardless of the rate of charge.
The charging method is two staged. The first stage of attempting to break down the sulfation to allow the battery to accept a charge must be closely
watched to avoid excessive charge rates as the battery begins to charge and overheating. The second stage is a slow charging to restore the
battery to full charge.
READ AND FOLLOW ALL PRECAUTIONS AND WARNINGS IN YOUR INSTRUCTION MANUAL BEFORE ATTEMPTING TO CHARGE
SULFATED BATTERIES. FAILURE TO OBSERVE THESE WARNINGS MAY RESULT IN PROPERTY DAMAGE OR SERIOUS PERSONAL
INJURY OR DEATH.
To recharge a sulfated battery:
Attach the battery clamps as described in the instruction manual.
1.
Always use the chargers lowest rate when turning the charger on. Set the charger to the chargers highest rate for the voltage of the battery
2.
being charged.
CAUTION: NEVER CHARGE A BATTERY AT VOLTAGES RATES ABOVE THAT OF THE BATTERY.
The battery will show little or no amperage at the start of the charging process. This will continue until the sulfation begins to break down.
3.
CAUTION: AS THE SULFATION BREAKS DOWN, THE AMPERAGE MAY RAPIDLY RISE. CONSTANT
ATTENTION MUST BE OBSERVED TO PREVENT SERIOUS OVERHEATING OF THE BATTERY.
Lower the charge rate to the lowest rate for the voltage of battery being charged.
4.
Charge the battery at this low rate until the electrolyte reaches the fully charged state as described in the tables in your instruction manual.
5.
This may take as long as two or three days.
NOTE: SOME BATTERIES MAY BE SO BADLY SULFATED THEY CAN NOT BE RESTORED TO A NORMAL OPERATING CONDITION,
REGARDLESS OF THE RATE OF CHARGE OR THE LENGTH OF TIME THE CHARGE IS APPLIED. IF THE BATTERY CANNOT BE
RESTORED TO A FULLY CHARGED CONDITION BY A SLOW CHARGING, IT SHOULD BE REPLACED.
4

Publicidad

Tabla de contenido
loading

Tabla de contenido