Setting The Self-Clean Mode; To Set The Self-Clean Mode; To Change The Cleaning Time; To Delay The Start Of Cleaning - Forza FOSP30S Manual De Uso Cuidado

To Set the Self-Clean Mode

1. Press the ON/OFF knob and select the icon
confirm with the same knob .
2. A message will appear on the screen prompting
simultaneous rotation of the knobs followed by removal of
all the objects and accessories from the compartment.
3. Press the [FUNCTION] knob to start door lock and cleaning
cycle.
4. The clean time is displayed automatically, its standard value
is 3 hours (min. 2h - max 4h).
5. At the end of the programmed cleaning time, the oven will
automatically turn off.
• To stop the cleaning mode at any moment, press ON/OFF
knob.
• The Self Cleaning cycle cannot be selected if the door is
open.
• If the door is in the open position when the function has
already been selected and the [FUNCTION] knob is pressed
the latch doesn't move, the "PADLOCK" icon will flash until
the door will be closed and the lock motor stops. When the
"CLOSED PADLOCK" it is displayed, the door cannot be
opened.
• Check that the door has been locked, if door does not lock,
press ON/OFF knob and do not start self-clean; phone for
service.
• Do not attempt to open the door while the cleaning cycle is
running and the door is locked.

To Change the Cleaning Time

1. To change the setting from 3 hours, select 4 either 2 hours
for light soil immediately after starting.
2. To change the hours, rotate the [FUNCTION] knob to the
RIGHT and select icon, (the hours will flash), use the
[FUNCTION] knob to change the value, than confirm by
pressing the [FUNCTION] knob.
3. Automatically the minutes will flash, use the [FUNCTION]
knob to change the value, than confirm by pressing the
[FUNCTION] knob.

25 - Setting the Self-Clean Mode

To Delay the Start of Cleaning

and then 1. Follow steps 1 through 3 above.
2. Touch the
on the display. The hours will begin flashing, use the
[FUNCTION] knob to change the value, than confirm by
pressing the [FUNCTION] knob.
3. Automatically the minutes will flash, use the [FUNCTION]
knob to change the value, than confirm by pressing the
[FUNCTION] knob.
8. When the delay time expires, self-cleaning will start.
9. At the end of the programmed cleaning time, the oven will
automatically turn off.
CAUTION
Keep in mind that the oven door will remain locked until it is
safe enough to open. The lock symbol will disappear from
the display when the door lock is released.
You will still need to exercise caution when the door lock is
released because the inside of the oven may still be hot.
After the self-clean cycle is complete the oven control
monitoring the internal temperature and the following
messages will be displayed:
• From the 460°C/860°F to 270°C/518°F= "End Self Cleaning"
• From the 270°C/518°F to 50°C/122°F= "Waiting to Clean"
• From the 50°C/122°F to 25°C/77°F= "Remove Residues"
(Press ON/OFF key to clear the message).
You may notice a powder ash residue in the bottom of the oven
after self-cleaning. This condition is normal. Use a damp cloth
or sponge to wipe up the residue after the oven cools down.
Self-cleaning Tips:
If any soil remains in the oven after the self-clean cycle is
complete, you may repeat the cycle if you want.
Self-clean the oven regularly to prevent excessive soil build-
up. Doing so will make the self-clean cycle work better and
reduce smoke and odors.
37
icon and verify that "STOP TIME" appears
EN