Movement RTE Manual De Instrucciones página 30

OPERATIONAL INSTRUCTIONS
PAGE OF CONFIGURATIONS
This control panel has the following configurable parameters.
1)Equipment model: Bicycle (bike) -> Elliptical (EliP);
2)Total Distance;
3)Total Time;
4)Version of Firmware;
PPress and hold the STOP / RESET and the START / ENTER keys at the same time for 3
seconds, until the first Parameter (bike -> EliP) is shown on the SPEED screen, press or
▲
▼ in order to configure the equipment model and press START / ENTER to confirm and
select the next parameter.
The next step will show the total distance (accumulated distance or odometer) on the
distance screen. Press START / ENTER to select the next parameter.
The next step will show the total time (accumulated time or timer) on the time screen.
Press START / ENTER to select the next parameter.
The next step will show the firmware version on the Distance screen. Press START / ENTER
to finish.
Total time and distance
Total time: 9999 hours -> 0001 = 1 hour
Total Distance: 9999km x 10 -> 0001 = 10 km
30