Kit Assembly - Metra 99-8234 Instrucciones De Instalación

DIN radio provision with pocket
1. Slide the brackets onto the sides of the
radio housing until the side clips engage.
(Figure A)
Note: Tabs are marked Left and Right.
2. Remove the metal DIN sleeve from the
aftermarket radio.
3. Slide the DIN sleeve into the radio
housing and secure by bending the
metal locking tabs down. (Figure B)
4. Slide the radio into the sleeve and
secure. (Figure C)
5. Snap the trim plate into the radio
housing. (Figure C)
6. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using
the proper mating adapter from Metra
and/or AXXESS. Test the radio for proper
operation.
7. Reassemble the dash in reverse order of
disassembly.

KIT ASSEMBLY

(Figure A)
(Figure B)
(Figure C)
ISO DIN radio provision with pocket
1. Slide the brackets onto the sides of the
radio housing until the side clips engage.
(Figure A)
Note: Tabs are marked Left and Right.
2. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
3. Mount the ISO brackets to the radio
with the screws supplied with the radio.
(Figure B)
4. Slide the radio into the radio opening
until the side clips engage. (Figure C)
5. Snap the trim plate into the radio
housing. (Figure C)
6. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using
the proper mating adapter from Metra
and/or AXXESS. Test the radio for proper
operation.
7. Reassemble the dash in reverse order of
disassembly.
(Figure A)
(Figure B)
(Figure C)
REV. 9/13/2017 INST99-8234
3