Kit Assembly - Metra 99-9229G Instrucciones De Instalación

ISO DIN radio provision with pocket
1. Secure the pocket to the radio
housing using (4) #8 x 3/8" Phillips
screws provided. (Figure A)
Note: Rounded edge of pocket
faces towards the bottom.
2. Remove the metal DIN sleeve and
trim ring from the aftermarket radio.
3. Slide the radio into the completed
assembly, and then secure it to the
assembly using screws supplied
with the radio. (Figure A)
4.
Locate the factory wiring harness and
antenna connector in the dash, and
complete all necessary connections to the
radio. Metra recommends using the proper
mating adapter from Metra and/or AXXESS.
Re-connect the negative battery terminal
and test the radio for proper operation.
5. Reassemble the dash in reverse
order of disassembly.
6. Attach (4) panel clips supplied to
the radio trim panel, and then snap
the panel over the radio.

Kit Assembly

(Figure A)
99-9229G
ISO Double DIN radio provision
1. Slide the radio into the radio
housing and secure it using screws
supplied with the radio. (Figure A)
2. Locate the factory wiring harness
and antenna connector in the
dash, and complete all necessary
connections to the radio. Metra
recommends using the proper
mating adapter from Metra and/or
AXXESS. Re-connect the negative
battery terminal and test the radio
for proper operation.
3. Reassemble the dash in reverse
order of disassembly.
4. Attach (4) panel clips supplied to
the radio trim panel, and then snap
the panel over the radio.
3
(Figure A)