Troubleshotting - GiBiDi F 12 Rally Manual Del Usuario

F12 RALLY

TROUBLESHOTTING

Before any installation or maintenance operation, ensure that the power has been cut !!
Only use original Gi.Bi.Di. spare parts and accessories.
FAULT
Red LEDs DL1 and DL2 on
The operator does not open
or close
Red LED DL3 off
Red LED DL5 off
After run time does not reclose
When pressing the 2nd key of
the remote control, the pedestrian
function is not activated
The transmitter has
a short range
The card does not learn
the TX code
When wiring or inserting the RADIO MODULE, the control unit must not be powered.
The control unit must be used strictly following the instructions provided by the manufacturer on
pain of forfeiture of the guarantee.
Installation and/or maintenance must be carried out by qualified personnel in compliance with the
provisions of the laws in force.
The manufacturer cannot be held responsible for damage caused by improper and/or irrational use.
Gi.Bi.Di. reserves the right to make modifications at any time and without prior notice in order to improve the product.
POSSIBLE CAUSES AND SOLUTIONS
Control unit in programming phase. Set DIP1 to OFF
Check that the red LEDs DL5 and DL3 are on and check good
functioning of the photocells.
Check that the photocells are properly connected.
Check the fuse F2 (10 A).
Check that the STOP input is connected to a normally closed button or
that a jumper has been placed between terminals 5 and 6
(CAUTION: STOP causes a functional stop NOT a safety stop)
Check that the trimmers RV1 and RV2 are not completely turned anticlockwise
Check that DIP5 is set to ON and that the pedestrian key of the remote
control has been learned.
Check that the antenna is positioned properly (braid - terminal 20, core -
terminal 21, if a control unit with built-in radio, code AS04260).
If using a plug-in receiver (code AU01710), the antenna must be
connected to the terminals on the receiver.
Check that there are no sources of disturbance or radio links in the
vicinity which limit the range.
Check that the max. number of codes (200) storable has not been reached.
Check if remote controls of the same family as the first are being learned:
DIP- SWITCH or ROLLING.
Check that the frequency of the radio control is the same as that of the receiver.
21
UK