Horizon Global 76396 Instrucciones De Instalación página 3

Always wear SAFETY GLASSES
when installing hitch
Conical washer
teeth side
against hitch
Fasteners
typical
both sides
2. Install hitch – Raise hitch into position and align with mounting hole. Loosely install (6) M12 bolts ① and (6) 1/2"conical washer ②, see Figure 1.
1. Clean access holes – Using tap, remove paint/debris from weldnuts, both sides.
3. Tighten all M12 fasteners with torque wrench to 76 Ft.-Lb. (103 N*M).
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged
should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch. This product complies with safety specifications and requirements for
connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2021 Horizon Global™ Corp - Printed in Mexico
Installation Instructions
PART NUMBERS: 76396, 84396, CQT76396
Existing Weldnuts
Forward
Figure 1
Sheet 3 of 12
Fastener Kit: 76396F
① Qty. (6) BOLT
M12 x 1.25 x 35 CL8.8
② Qty. (6) CONICAL WASHER
1/2"
76396NP 01-14-21 Rev. A