DJO ARTROMOT-S3 Instrucciones De Uso página 70

• The stop position at the end of each
tenth cycle (for both adduction/
abduction and internal/external rota‑
tion) can be selected in steps of 25%
between 0% and 100% of the pro‑
grammed maximum range of motion.
• Steps 1 and 2 can be repeated as
often as needed. You can stop treat‑
ment with the STOP key; after the
programmed therapy duration, it will
stop automatically.
During the isolation protocol, the
display will show the symbol
in the upper, left‑hand corner.
Default: disabled
Follow these steps to program the
special function:
• Access menu level 4, then press the
parameter key to select the special
function. The display will indicate:
− the symbol representing the special
function
– the status of the special function
(circle with or without check mark)
– two boxes with the current per‑
centage of the stop positions for
motor A and B
– a check mark in a circle
• You activate the function with the "+"
key and deactivate it with the "‑" key.
In this case it is not possible to activate/
deactive the function by pressing the
parameter key again. A check mark
in the circle identifies the activated
function.
• Next press the parameter key of the
isolation protocol. The dotted frame
moves to the upper percentage value,
allowing you to enter the stop position
for motor A.
• To modify the value, press the "+" (plus)
or "–" (minus) key. Select 75%,
for instance.
• Press the parameter key again when
done. The dotted frame automatically
moves to the lower value, allowing you
to adjust the stop position of motor B.
• To modify the value, press the "+" (plus)
or "–" (minus) key. Select 25%,
for instance.
• Save the programmed values by press‑
ing the STOP key, then press the START
key to begin the treatment.
This is what happens:
Abduction / adduc tion is treated ten times
first (motor A). Motor B is positioned at
25% of the programmed range of motion
for internal and external rotation.
Subsequently, internal / external rotation
is treated ten times (motor B). Motor A
is positioned at 75% of the programmed
range of motion for adduction and
abduction.
Note!
The percentage values can be modi‑
fied only when the special function is
enabled (check mark).
n Therapy documentation
adduction/abduction
This is a special function of
ARTROMOT®‑S3 Comfort which allows
the entire therapy documentation to be
represented.
The carriage run times as well as the
range of motion of the sessions are
recorded.
The collected data are presented
graphically in the form of a coordinate
system (X‑axis = range of motion /
Y‑axis = time) where the upper curve
illustrates the trend of the abduction
movement and the lower curve the
trend of the adduction movement.
n Therapy documentation
internal / external rotation
This is a special function of
ARTROMOT®‑S3 Comfort which allows
the entire therapy documentation to be
represented.
The carriage run times as well as the
range of motion of the sessions are
recorded.
The collected data are presented graph‑
ically in the form of a coordinate system
66