KTM Power Parts AKRAPOVIC Manual Del Usuario página 10

18
B
19 B
20
2
4
22
A
3
22
A
A
23
Mounting the exhaust 390 Duke + RC
- Mount the bushings and rubber bushing (18) (included in kit B) on the
presilencer (2) (included).
NOTE:
When mounting the exhaust system, initially hand tighten the screws only. After
B
completely mounting the system, align the entire system and tighten the screw
connections fully.
- Slide exhaust clamp (19) (included in kit B) onto the presilencer (2) (inclu-
ded). Connect the presilencer to the original manifold and mount.
- Mount speed nut (20) (included in kit B) on the inside.
- Mount screw and washer (21) (included in kit B) on the inside of the chas-
sis.
21
B
Unlike the original exhaust system, the fixing tab of the AKRAPOVIC must
be mounted on the inside of the frame tab.
RC 390 only
- Mount RC retaining bracket (4) on the right passenger footrest bracket with
screws and washers (22) (included in kit A) and tighten.
390 Duke only
- Mount Duke retaining bracket (3) on the right passenger footrest bracket
1
with screws and washers (22) (included in kit A) and tighten.
- Connect main silencer (1) (included) and mount with screw and washer
(23) (included in kit A).
- Mount the exhaust springs (24) (included in kit B).
- Align the entire exhaust system and tighten all screws.
B
24
When using the main silencer for the first time, the engine rpm must be kept
low for roughly the first 5 minutes to evenly heat the main silencer. This ensu-
res that the rock wool will reach its full effectiveness and keep the volume
down to the required level.
24 B