GYS GYSFLASH 50-12 HF Manual De Instrucciones página 13

DIAG
U=13.5V
DIAG + MODE CONFIGURATION
DIAG+
U=13.5V
3 sec
SELECT
DIAG+
SELECT
U=13.5V
SELECT
DIAG+
U=27.2V
Start up :
• Connect the clamps : red to the (+) and black
to the (-) of the battery.
• Push the START/STOP key to start the mode.
• During use the current consumed and the ins-
tantaneous voltage are displayed.
Precaution : Before using the Diag Mode. If the screen displays a current greater than 10A, it indicates the battery is discharged.
The device will start charging automatically. Check all electrical consumers are switched off on the vehicle. Wait until the current falls
below 10A and then re-launch the diagnostic.
SHOWROOM MODE
On a stationary vehicle, the GYSFLASH supplies up to 50A to test high-energy consumers (engine fan, window regulator, electronic
suspension, etc...) by supplying a steady voltage adjustable:
- 12V to 14.8V (for 12V battery)
- 24V to 29.6V (for 24V battery, adjustable only on the GYSFLASH 50-24 HF)
- 6V to 7.4V (for 6V battery, adjustable only on the GYSFLASH 50-24 HF)
Volatage adjustment:
After selected the battery voltage (6V/12V/24V for the GYSFLASH 50-24 HF) it is possible to adjust the voltage to an accuracy of 0.1V SHOWROOM
according to the manufacturer's specifications.
13.5V
SHOWROOM MODE CONFIGURATION
SHOWROOM
U=13.5V
3 sec
SELECT
SHOWROOM
SELECT
U=13.5V
SELECT
SHOWROOM
U=27.2V
DIAG
GYSFLASH 50-12 HF / 50-24 HF
START
STOP
U=13.5V
12V
6 V
12V
12 V
24 V
6.0V
24V
6.1V
...
7.4V
SHOWROOM
START
STOP
13.5V
12V
6 V
12V
12 V
24 V
6.0V 12.0V
24V
6.1V 12.1V
... ...
7.4V 14.8V
I=12A
6V and 24V available only on the
Gysflash 50-24 HF.
12.0V 24.0V
12.1V 24.1V
... ...
14.8V 29.6V
DIAG MODE START UP
DIAG
U=13.5V
DIAG+
U=13.5V
3 sec
SELECT
DIAG+
SELECT
U=13.5V
SELECT
12A
DIAG+
U=27.2V
6V and 24V available only for the
Gysflash 50-24 HF.
24.0V
24.1V
...
29.6V
DIAG
START
STOP
U=13.5V
12V
6 V
12V
12 V
24 V
6.0V 12.0V
24V
6.1V 12.1V
...
7.4V 14.8V
EN
I=12A
24.0V
24.1V
... ...
29.6V
13