Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
APF : Open, Stop, Close;
To set the Operation Mode set the PROG switch to the position as shown in
the figure below, and press the LEARN button according to the desired setting:
PROG SWITCH POSITION
1 time
APFP
28 - PHOTOCELL SETTINGS
In this mode it is possible to configure the photocell operation mode:
NA: Normal operation (Normally Open);
Photocell Closes: In this mode, after leaving the front of the photocell the gate
closes automatically after counting the set time.
Count Queue: In this mode, upon receiving a pulse from (Pushbutton Opens),
the switch adds 1 to the counter, and will only close the gate after passing in
front of the photocell.
Example: If 3 pulses are received at the pushbutton (Opens), it will be necessary
to perform 3 triggers on the photocell to close the gate.
To configure photocell operation, set the PROG switch to the position
as shown in the figure below, and press the LEARN button according to the
desired setting:
PROG SWITCH POSITION
1 time
FTC NA
LED BLINKS
2 times
AF
PHOTOCELL SETTINGS
LED BLINKS
2 times
PHOTOCELL CLOSES
INGLÊS
PROGRAMMING
OPERATION MODE
3 times
APF
PROGRAMMING
3 times
COUNT QUEUE
73
Publicidad
Tabla de contenido
