Changing The Rotor Blades - Revell Control Lateralis Manual Del Usuario

If the rotor blade of the helicopter are damaged, they must be replaced.
Proceed as follows:
Prior to installation, make sure that you do not mix up the rotor blades.
9B Carefully pry the rotor blade off the mount.
9C Now carefully remove the rotor blade from the mount
9D Carefully fit the new rotor blade in the mount.
Attention: Please DO NOT USE FORCE.
Problem: The rotor blades do not move.
Cause: • The ON/OFF switch is in the "OFF" position.
• The battery is too weak or depleted.
Remedy: • Set the ON/OFF switch to the "ON" position.
• Charge the battery.
Problem: The helicopter stops and descends during flight for no apparent
reason.
Cause: • The battery is too weak.
Remedy: • Charge the battery.
Problem: it isn't possible to control the helicopter using the remote control.
Cause: • The ON/OFF switch is in the "OFF" position.
• The batteries were not inserted correctly.
• The batteries do not have enough power.
Remedy: • Set the ON/OFF switch to the "ON" position.
• Check whether the batteries are inserted correctly.
• Insert new batteries
Problem: The helicopter only rotates around its axis clockwise or
anti-clockwise.
Cause: • Excessive trim adjustment to the left or right.
Remedy: • Resetting of the left/right trim control in the opposite direction
(see point 6, Steering trim adjustment).
Additional tips and tricks can be found online at www.revell-control.de.
20

9 ChaNgINg The rOTOr BlaDeS

TrOUBleShOOTINg