Problem Solving - Eureka 6500 Serie Manual Del Usuario

ENGLISH

Problem Solving

CAUTION: Turn off the switch and unplug the electrical cord before servicing.
Problem
Motor will not start.
Does not clean carpet or bare
floor
No suction at the end of the hose
Headlight is not working
Noise from the brush roll area
Brush roll with not turn
Cleaner shuts off
General questions
Airextreme lid will not close
1-800-8-88
Cause
Electric Plug
Power switch not turned
"ON"
Dust Cup or bag and
Filter(s)
Belt
Brush Roll
Hose
Bare Floor Setting
Dust Cup and Filter(s)
Full paper bag or dust cup
Paper bag/filter clogged
Hose clogged
Light bulb
Brush roll
Belt
Belt
Internal safety thermostat
trips (see page 5 for
details)
Assembly or related
attachments
Dust Bag and Air Basket
not installed
1
Solution
• Push plug securely into outlet.
• Try another outlet.
• Check circuit breaker.
• Turn on/off switch to |.
• Empty the dust cup and/or change the bag.
Change or clean the filters. Hint: If picking up
fine dust, the dust cup/bag may not look full,
but a fine substance tends to reduce suction
when it blocks airflow through the foam filter.
Make sure the foam filter is installed properly.
• Replace a cut, or out of shape belt.
• Clean hair and thread from bristles and end
cap area. Replace brush roll if bristles are
worn.
• Remove any clogs from the hose that restrict
the airflow.
• For bare floor cleaning, make sure switch
control is in bare floor position.
• Empty the dust cup and/or change the bag.
Change or clean the filters. Hint: If picking up
fine dust, the dust cup/bag may not look full,
but a fine substance tends to reduce suction
when it blocks airflow through the foam filter.
Make sure the foam filter is installed properly.
• Replace paper bag/empty dust cup
• Replace paper bag/replace or clean filters
• Remove any clogs from hose that restrict
airflow, then try again.
• Replace light bulb. See page 11.
• Remove base plate and clean debris from the
brush roll compartment.
• Replace a cut or out of shape belt.
• Replace a cut or out of shape belt.
• Unplug cleaner and check for obstructions in
hose, wands and attachments.
• Check for full paper bag or cup.
• Clean/replace motor filter.
• Call 1-800-282-2886 between 8:00 a.m. to
7:30 p.m. CST Monday through Friday and
10:00 a.m. to 6:30 p.m. CST on Saturday and
Sunday. Know the Model number and Serial
number when you call.
• Install Bag and Air Basket.