ASSEMBLING YOUR STROLLER
5
H
J
K
I
M
Begin assembly of the rear wheels and axle assembly by discarding all packaging.
Slide one wheel
H
and a steel washer
I
onto the axle
wheel, as shown. Make sure the clevis pin is completely pushed through the hole in the
housings
L
are facing the same direction. Note:
Install the hub cap
on the wheel by lining up the notch
M
completely until it snaps into place. Repeat on the other side.
R
P
Q
6
T
4
I
K
J
L
J
. Insert a clevis pin
K
through the end of the axle
axle, and make sure the brake
An extra clevis pin and steel washer are included for your convenience.
with the tallest rib
in the wheel hub. Insert the hub cap
N
O
Turn the stroller upside down.
Install H-frame
P
to stroller frame legs
place with audible clicks.
Hold the rear wheel/axle assembly so the brake levers
toward the handle and console.
Slide the brake housings onto the H-frame until they lock into
place with audible clicks.
Pull upward on the rear wheel/axle assembly to make sure it
is locked securely.
Slide the front wheel assembly
S
over the front frame leg
until the locking tab
locks into place with an audible click.
U
Pull on front wheel assembly to make sure it is locked
securetly. Repeat for other side.
Note: To remove each swivel wheel, press locking tab
S
slide the wheel off the leg.
U
7
O
N
V
M
W
J
to secure the
8
Q
until they lock into
R
face
C
1
A
T
2
U
and
Insert the canopy support tubes
the stroller
Pull upward on the canopy tubes to make sure they are
locked securely.
B
Bring the parent's console
Gently pull out the side of the console and guide the hole
over the post
console.
X
Y
Pull canopy hoop
Push canopy toward handle to close.
Step on the rear brake levers
the stroller.
To release the brakes, lift up on the brake levers.
B
ASSEMBLING YOUR STROLLER
V
into the canopy hinges on
until they lock into place with audible clicks.
W
V
W
up to the parent's handle
.
B
C
X
. Repeat on the other side of the parent's
Y
USING YOUR STROLLER
A
forward to extend canopy.
B
to lock the rear wheels on
5