Culligan SY-1000S Instrucciones De Instalación Y Funcionamiento página 4

R. Filter Cartridge Replacement
NOTE: It is recommended that the filter be replaced every six months, or when you notice
a change in taste, odor, or flow of the water being filtered.
(1) Turn off water supply to the filter and dispense water from drinking water faucet until
water flow stops to relieve pressure.
(2) Place towel under the system to catch any water drips.
(3) (a) Turn arrow from locked to unlocked position and
(b) remove cartridge.
(4) (a) Line up arrow with unlocked position on head and insert cartridge.
(b) Turn to locked position.
(5) Turn on water and check for leaks. If it leaks, see Troubleshooting.
(6) Flush water through drinking water faucet for 5 minutes to remove carbon fines. Check
for leaks before leaving installation. If it leaks, see Troubleshooting.
Troubleshooting
Leaks:
...Between head and cartridge
(1) Turn off the water supply to the filter and dispense water from drinking water faucet
until water and airflow stops.
(2) Remove cartridge and inspect o-rings to make sure they are in place and clean.
(3) Install cartridge and turn on water supply. If it still leaks, contact Technical Support at
1-800-645-5426 M-F 7:30 AM-5 PM CST. Turn off icemaker if filtered water goes to
icemaker.
...From fittings
Turn off water supply to the filter and turn on drinking water faucet to release pressure in
system. For plastic tubing, loosen the compression nut and pull the tubing from the brass
fitting. Inspect to see if the ferrule and insert are properly installed on the tubing. Check if
tubing is cut squarely. If so, reconnect tubing finger-tight, then tighten nut snug about
to 1 turn with a wrench. Open the water supply valve, then close faucet and check for
leaks. If the leaks persist, or if there are other leaks on the unit, turn off the water supply
then call Technical Support at 1-800-645-5426.
...on supply adapter connection
Turn off water supply valve and turn on drinking water faucet to release pressure in system.
Loosen leaking threaded fitting on supply adapter or pull out leaking tubing from fitting.
Inspect to see if plastic tubing is scratched or supply adapter was properly attached. If
tubing is scratched, cut off 1 / -inch to
2
the Water Supply Adapter. Reconnect tubing or tighten compression nut with fingers, then
tighten nut snugly 1/2-turn with wrench. Turn on water supply valve and check for leaks.
...on faucet/tubing connection
Turn off water supply valve and turn on drinking water faucet to release pressure. Loosen
and remove compression nut fitting on faucet stem. Check if tubing is cut squarely. Make
sure tubing is inserted firmly into end of faucet stem, then retighten compression nut with
fingers until secure, then tighten nut snugly
valve, then close faucet and check for leaks.
NOTE: If leaks persist, or if there are other leaks on system, turn off water supply. Call our
technical support department at 1-800-645-5426.
5 / -inch and reinstall per Step Three: Connecting
8
1
/ -turn with wrench. Turn on water supply
2
R3
b
R4
a
1
/
2
4
a
b