Testing Functions; Using The Parking Aid - Dometic MagicWatch WPS 900F Manual Del Usuario

WPS900F/WPS910
9

Testing functions

Complete the functional test of the rear sensors as follows:
➤ Release the handbrake.
➤ Switch on the ignition and engage the reverse gear.
Be very careful when you use the device for the first time, and make sure that you
familiarize yourself with the various sequences of beeps (see fig. e).
A
NOTICE!
In zone 4, some obstacles may not be detected, because they are no
longer within range of the sensors (construction-related characteristic).
Test the front sensors the same way. To do so, drive slowly, for example, towards
a wall.
10

Using the parking aid

The rear sensors are automatically activated when you engage the reverse gear
when the ignition is on or the engine is running.
The front sensors are activated automatically:
• by starting the vehicle
• by engaging the reverse gear
• by lowering the vehicle speed to less than 10 km/h
• by pressing the right button on the control unit
• by pressing the external switch
When the front sensors are activated, the LED on the external button and the
yellow LED on the control unit both light up.
If the speedometer signal cannot be detected, the front sensors are activated when
the ignition is switched on. Once the adjustable switch-off time has elapsed, they are
deactivated automatically.
As soon as there is an obstacle within the detection range, a steady signal tone is
emitted repeatedly.
As you approach, the tone sequence will change according to the zone in which the
obstacle is, thereby indicating the distance (fig. e applies to the front sensors).
Be very careful the first time you use the system, until you are familiar with the various
sequences of beeps.
EN
Testing functions
19