Operator Instructions; Construction And Control; Turning The Converter On; Loading The Paper - Ranpak PadPak SR PPC5 Manual Del Usuario

PadPak PPC5

3. OPERATOR INSTRUCTIONS

EN
Before operating the converter, the
information from
be read and understood.
Warning!
3.1

Construction and Control

· 1 Emergency Stop circuit, which includes:
◦ 1 Emergency Stop button
◦ 1 Front cover safety switch
◦ 1 Rear cover safety switch
· 1 or 2 foot switches
· 1 On/Off main switch
· 1 End of Web sensor
· 2 line power fuses
3.2

Turning the Converter On

First, check that the following conditions are met:
· The foot switch is plugged in
· The Emergency Stop button is deactivated
· All covers are closed
· Hands are free from the converter exit chute
Then follow these steps:
· Plug the power plug into the wall socket with ground
contact
· Set the main switch to "On" or "I" (the display shows 3
dots " . . . ")
· Press "Stop/reset"; the converter is now stand-by
(Display shows " 0").
The converter is now ready for use.
3.3

Loading the Paper

Pay attention when using hand tools
such as knives, scissors etc, due to the
risk of cutting!
Warning!
Place the paper roll (max 45 Kg - 100 lbs)
always with 2 people in the converter.
Pay attention to ergonomic factors
Warning!
such as lifting, bending, reaching, etc.!
To load a paper roll in the converter, complete the following
steps:
1. Ensure all covers are closed and the Emergency Stop
button is not activated.
2. Turn the main switch to "On" or "I".
3. Caution: Mind your hands, risk to pinch,
3
Section "Safety" must
2-plies of paper
4.
5.
6.
PadPak PPC5 Operator Manual - EN
3-plies of paper