INSTALL DUCT CONNECTOR
1. Install the damper duct connector onto the
hood using mounting screws (3,9x9,5mm)
as shown in Fig.2
2. Remove the tape located on the damper.
See Fig.2.
INSTALL JUNCTION BOXE
In the area marked "120 VAC INPUT", place
a junction box on the top of the hood. Run
the wires through the hole below and secure
with (2) 3,9 x9,5 screws and (2) washers. See
Fig.3-4.
INSTALL THE DUCTWORK
NOTE: To reduce the risk of fi re, use only
metal ductwork.
1. Decide where to install the duct.
2. A straight, short duct will allow the hood to
perform most effi ciently.
3. Long duct, elbows, and transitions will re-
duce the performance of the hood. Use as
few of them as possible.
4. Use duct tape to seal the joints between
ductwork sections.
Ducted confi guration
Install a roof or wall cap. Connect the round
metal ductwork to cap and work back towards
hood location.
Non-Ducted confi guration
nstall a decorative grill (not supplied by Best).
I
You may need to purchase a metal round-
to-rectangular transition depending on your
application.
2 MOUNTING SCREWS
(3,9 x 9,5mm)
"120 VAC INPUT"
P195P2M70SB-P195P1M70SB6 Models
(shown in Fig.1a):
(shown in Fig.1b):
2 Washers
Fairlead
MARKED
DUCTED CONFIGURATION
HOOD
24" TO 30" ABOVE
COOKING SURFACE
NON-DUCTED CONFIGURATION
Models:
P195P1M52SB6-P195P1M70SB6
(6" DUCT CONNECTOR)
MOUNTING SCREWS
(3.9x9.5mm)
REMOVE THE TAPE
MOUNTING SCREWS
(3,9 x 9,5mm)
2 Washers
P195P1M52SB6 Model
Fig.4
- 5 -
ROOF CAP
ROUND
DUCT
WALL
CAP
ROUND
ELBOW
P195P2M70SB
(8" DUCT CONNECTOR)
MOUNTING SCREWS
(3.9x9.5mm)
REMOVE THE TAPE
"120 VAC INPUT"
Fairlead
Fig.1a
Fig.1b
Model:
Fig.2
MARKED
Fig.3