Troubleshooting Tips; Do's And Don'tS - Ranpak FillPak TTC Manual Del Operador

FillPak TT with Cut Mechanism
®
5.4

Troubleshooting Tips

5.4.1 Do's and Don'ts

Do
Place converter in correct position. Make sure the
converter has the correct height and the head is positioned
in an angle of approx. 45 degrees (1
Do
Wait for the cut mechanism to complete its cutting cycle
(approx. 1 sec.) before pulling the paper out of the
converter.
Do
Remove any box or object blocking the converter opening
to allow paper to feed through freely. If possible, move
the TT stand back or raise it higher to add more space
between the paper and box contents.
FillPak TT with Cut Mechanism Operator Manual - EN
®
or 2 tilt position).
st nd
Don't
Do not place the head of the converter in vertical position.
If the head is in the last position or lowest tilt, the paper
may jam.
Don't
Do not pull paper out of the converter until it has been cut.
Do not pull the paper out of the converter horizontally or
any other way than the direction of the converter.
Don't
Do not block the opening of the paper chute or converter
by operator's hands, a box or any kind of object.
EN
10