Changing The Basic Settings; Basic Settings; Care And Cleaning; Cleaning Agents - Siemens HB84H501 Instrucciones De Uso

Changing the basic settings

Your appliance has various basic settings which you can
change at any time.

Basic settings

In the table, you will find all the basic settings and options for
changing them.
Basic setting
Clock display
™‚
= on
‚
Signal duration
™ƒ
ƒ = medium = 2 minutes
Signal volume
™„
ƒ = medium
Waiting time
™...
ƒ = medium = 5 seconds
Requirement: Your appliance is switched off.
Press and hold the button for several seconds.
0
1.
The first basic setting appears in the display.
Use the or button to change the basic setting.
@ A
2.

Care and cleaning

With careful care and cleaning your microwave oven will retain
its looks and remain good order. We will explain here how you
should care for and clean your appliance correctly.
:
Risk of electric shock!
Do not use any high-pressure cleaners or steam cleaners,
which can result in an electric shock.
:
Risk of burns!
Never clean the appliance immediately after switching off. Let
the appliance cool down.
:
Risk of serious damage to health!
Microwave energy may escape if the cooking compartment
door or the door seal is damaged. Never use the appliance if
the cooking compartment door or the door seal is damaged.
Contact the after-sales service.
Notes
Slight differences in colour on the front of the appliance are
■
caused by the use of different materials, such as glass,
plastic and metal.
Shadows on the door panel which look like streaks, are
■
caused by reflections made by the oven light.
Unpleasant odours, e.g. after fish has been prepared, can be
■
removed very easily. Add a few drops of lemon juice to a cup
of water. Place a spoon into the container as well, to prevent
delayed boiling. Heat the water for 1 to 2 minutes at
maximum microwave power.
38
Options
Clock display
= off
ƒ
‚ = short = 10 seconds
= long = 5 minutes
„
‚ = low
= high
„
‚ = short = 2 seconds
= long = 10 seconds
„
Confirm by pressing the
3.
The next basic setting appears in the display. You can go
through all of the basic settings using the
make changes using the
When finished, press and hold the
4.
seconds.
All settings are applied.
You can change the settings at any time.

Cleaning agents

To ensure that the different surfaces are not damaged by using
the wrong cleaning agent, observe the information in the table.
Do not use:
Harsh or abrasive cleaning agents.
■
Metal or glass scrapers to clean the glass in the appliance
■
door.
Metal or glass scrapers to clean the door seal.
■
Hard scouring pads or sponges.
■
Cleaning agents with a high alcohol content.
■
Wash new sponge cloths thoroughly before use.
Allow surfaces to dry thoroughly before operating the appliance
again.
Area
Appliance front
Appliance front with
stainless steel
Explanation
Displays the clock
Audible signal after the cooking time has
elapsed
Volume of the signal
Waiting time between two separate steps,
after setting
button.
0
or button.
@ A
0 button for several
Cleaning agents
Hot soapy water:
Clean with a dish cloth and then dry with
a soft cloth. Do not use glass cleaners
or metal or glass scrapers for cleaning.
Hot soapy water:
Clean with a dish cloth and then dry with
a soft cloth. Remove flecks of limescale,
grease, starch and albumin (e.g. egg
white) immediately. Corrosion can form
under such flecks. Special stainless-
steel cleaning agents are available from
the after-sales service or from specialist
retailers. Do not use glass cleaners or
metal or glass scrapers for cleaning.
0 button and