After-Sales Service; E Number And Fd Number; Technical Data - Siemens HB84H501 Instrucciones De Uso

Problem
It takes longer than before for the
food to heat up in the microwave
Turntable grates or grinds.
A particular operating mode or
power level cannot be set.
"‚ appears in the display panel.
appears in the display panel.
"ƒ
appears in the display panel.
"„
appears in the display panel.
"...
appears in the display panel.
"‚‚
appears in the display panel.
"‚ˆ
The appliance can be set, but does
not heat up. The colon is flashing.

After-sales service

Our after-sales service is there for you if your appliance needs
to be repaired. We will always find the right solution in order to
avoid unnecessary visits from a service technician.

E number and FD number

When calling us, please give the product number (E no.) and
the production number (FD no.) so that we can provide you with
the correct advice. The rating plate containing these numbers is
found on the side of the oven door. You can make a note of the
number of your appliance and the telephone number of the
after-sales service in the space below to save time should it be
required.
E no.
After-sales service O
Please note that there will be a fee for a visit by a service
technician in the event of a malfunction, even during the
warranty period.
Please find the contact data of all countries in the enclosed
customer service list.
To book an engineer visit and product advice
0344 892 8999
GB
Calls charged at local or mobile rate.
01450 2655
IE
0.03 € per minute at peak. Off peak 0.0088 € per
minute.
Rely on the professionalism of the manufacturer. You can
therefore be sure that the repair is carried out by trained service
technicians who carry original spare parts for your appliances.
40
Possible cause
The selected microwave power level is too
low.
A larger amount than usual has been placed
in the appliance.
The food was colder than usual.
Dirt or debris in the area around the turntable
drive.
The temperature, power level or combined set-
ting is not possible for this operating mode.
The thermal safety switch-off function has
been activated.
The automatic safety switch-off function has
been activated.
The oven is malfunctioning.
The thermal safety switch-off function has
been activated.
Moisture in the control panel.
Rapid heating has failed.
The demo mode has been activated.
FD no.
Remedy/information
Select a higher power level.
Double the amount = almost double the
cooking time.
Stir or turn the food during cooking.
Clean the rollers under the turntable and the
recess in the oven floor thoroughly.
Choose permitted settings.
Call the after-sales service.
Touch any button or turn the rotary selector.
Call the after-sales service.
Call the after-sales service.
Allow the control panel to dry.
Call the after-sales service.
Disconnect the appliance from the mains
power supply, then reconnect it. Press and
hold the
appears in the display and the colon stops
flashing. Confirm within 4 seconds using the
button.
@

Technical data

Power supply
Microwave power setting
Microwave frequency
Fuse
VDE approved
CE mark
This appliance corresponds to the standards EN 55011 and
CISPR 11. It is a Group 2, Class B product.
Group 2 means that microwaves are produced for the purpose
of heating food. Class B states that the appliance is suitable for
private households.
@ button until the @ symbol
220-230 V, 50 Hz
900 W
2,450 MHz
16 A
Yes
Yes