ST MPST 84 Li 48 V1 Manual Del Usuario página 60

9. The icon fig. 12.E stays on
and the battery LEDs1, 3
and 5 flash.
10. [Push-button panel Type I]
The icon fig. 12.E stays on
and the battery LEDs 1 , 2
and 4 flash.
[Push-button panel Type II]
The icons fig. 12.E
and fig. 12.N stay on
and the battery LEDs
1, 2 and 4 flash.
11. [Push-button panel Type I]
The icon fig. 12.E stays on
and the battery LEDs 1 , 2, 4
and 5 flash.
[Push-button panel Type II]
The icons fig. 12.E and
fig. 12.O stay on and the
battery LEDs 1, 2, 4 and 5
flash.
12. [Push-button panel Type I]
The icon fig. 12.E stays on
and the battery LEDs 1 , 2, 3
and 5 flash.
[Push-button panel Type II]
The icons fig. 12.E and
fig. 12.O stay on and the
battery LEDs 1, 2, 3 and 5
flash.
Cutting means motors
stalling due to:
1. Heavy working
conditions.
2. Obstructions
hindering the rotation
of the cutting means.
3. Cutting-means
assembly is full of
grass.
Overheating of the drive
motor due to:
1. Drive motor under
strain.
2. Slope too steep.
3. Excessive presence
of mud on the wheels.
The machine is started
with the drive pedal not
released (not in neutral
position).
Transmission
engagement/
disengagement lever in
transmission disengaged
position.
EN - 28
Reduce the travel speed
Increase the cutting height:
Remove the obstructions.
Clean the cutting-means assembly.
Turn off the machine and wait at least 5 minutes
before repeating the start-up procedure.
Reduce the travel speed
Reduce the speed and check the gradient of the
slope you are working on.
Make sure the wheels are not blocked and clean
them if necessary.
Turn the machine off and repeat the starting
procedure only after making sure that the drive pedal
is in neutral (pedal released).
Check the position of the transmission engagement/
disengagement lever and, if necessary, return it to
the engaged transmission position.
If the problem persists, please contact a Service
Centre.