Diode Test - koban KMD-14 Instrucciones Operativas

5. If the resistance is less than approximately 30Ω, the audible signal
will sound. The display will also show the actual resistance.

DIODE TEST

WARNING: To avoid electric shock, do not test any diode that has
voltage on it.
1. Set the function switch to
2. Press the
3. Insert the black test lead banana plug into the negative (-) jack (COM)
and the red test lead banana plug into the positive (+) jack (Ω).
4. Touch the test probe tips to the diode or semiconductor junction you
wish to test. Note the meter reading
5. Reverse the probe polarity by switching probe position. Note this
reading.
6. The diode or junction can be evaluated as follows:
A. If one reading shows a value and the other reading shows OL, the
diode is good.
B. If both readings show OL, the device is open.
C. If both readings are very small or 0, the device is shorted.
www.grupotemper.com
AUTORANGING MULTIMETER
position.
button until the symbol appears in the display.
KMD-14
19