Continuity Check; Diode Test - koban KMD-15 Instrucciones Operativas

KMD-15
DIGITAL MULTIMETER
than the actual or any anticipated resistance. The
display will indicate the proper decimal point and value.

CONTINUITY CHECK

WARNING: To avoid electric shock, never measure
continuity on circuits or wires that have voltage on them.
1. Set the function switch to the
2. Insert the black lead banana plug into the negative
(COM) jack
Insert the red test lead banana plug into the positive (Ω)
jack.
3. Touch the test probe tips to the circuit or wire you wish to
check.
4. If the resistance is less than approximately 30 , the
audible signal will sound. If the circuit is open, the
display will indicate "1".

DIODE TEST

1. Insert the black test lead banana plug into the
negative COM jack and the red test lead banana
plug into the positive diode jack.
2. Turn the rotary switch to the
3. Touch the test probes to the diode under test.
16
position.

position.
/ •)))
www.grupotemper.com