Before You Begin; Installation Review; Tools Needed; Parts Supplied - Bosch HDD80050UC Instrucciones De Instalación

BEFORE YOU BEGIN

Installation review

This downdraft system can be used to exhaust cooking
by-products such as heat, steam, and smoke that may
be created while cooking using gas or electric cooktops.
With its versatile design, there are fi ve (5) basic discharge
options - left, right, rear, front and recirculation. It is
important to fi rst plan your installation. The purchase of
additional accessories to complete the installation may be
necessary.
It can be mounted in an island, peninsula, or conventional
wall location. The blower (purchase separately) and
electrical panel can be mounted to the downdraft unit,
inside the cabinet, or in a convenient remote location.
This unit can be easily installed following these basic
steps:
Plan the installation.
•
Cut out the countertop opening.
•
Prepare the downdraft housing.
•
Cut out the cabinet opening for discharge.
•
Mount the downdraft in the cabinet.
•
Install gas cooktop seal kit accessory, if applicable.
•
Connect the ductwork and install the blower.
•
Install downdraft electrical panel, if in remote
•
location.
Install the cooking appliance.
•
Install end caps to downdraft.
•
Check the operation.
•
Note: the high level of air fl ow of this appliance may effect
the gas fl ame on some types of gas cooktops. This is
NORMAL and will cause no harm, but can be corrected
by lowering the speed of the blower.

Tools needed

Measuring tape
•
Pencil
•
Phillips screwdriver #2
•
Nut drivers - 11/32" (8.7mm), 3/8" (9.5mm), 7/16"
•
(11.1mm)
Box-end wrench
•
Spirit-level
•
Aluminum tape (DO NOT use insulating tape)
•
Saw
•
Tin snips
•
Work gloves
•
English 8

Parts supplied

1 Parts Bag containing:
2 - Screws, #8-18
2 - Screws,
x .375 (9.5mm)
1/4-20 x .50
Phillips
(12.7mm) Hex
Head
1 - Plastic
installation template
2 - End Cap Trim
(see pg. 14
2 - 2-in. (51mm)
2 - 4-in. (102mm)
Support Legs
Support Legs
Installation Installation
Use and Care guide
instructions instructions
Downdraft Ventilator Housing
8 - Wood Screws, #10
x .50 (12.7mm) Phillips
Round Head
)
1 - Electrical Panel 1 - Electrical Panel
2 - Upper Support Brackets 2 - Upper Support Brackets
Wiring diagram