A - Installation Using FL Exible Blower Attached To Downdraft; B - Installation Using FL Exible Or Remote Blower - Mounted In A Remote Location - Ducting Through Front Panel Opening - Bosch HDD80050UC Instrucciones De Instalación

INSTALLATION
Based on blower and ducting option
selected, go to the relevent section:
A - Installation using fl exible blower
attached to downdraft
B - Installation using fl exible or remote
blower - mounted in a remote
location - ducting through front
panel opening
C - Installation using fl exible or remote
blower - mounted in a remote
location - ducting through left,
right or rear
A - Installation using fl exible blower
attached to downdraft
(Purchase Model DHG602DUC Flexible Blower
separately.)
1. Remove hex nuts to remove front panel cover.
2. Determine whether fl ex blower will discharge to the left,
right, or down.
3. If blower discharge is down, remove (4) #8-32 hex nuts
and electrical panel.
4. Place blower over studs around front panel opening.
5. Tighten hex nuts to secure blower in place.
BLOWER
SUPPORT
LEGS
6. Remove bolts from fl ex blower housing. Attach blower
support legs to fl ex blower housing with these (4) bolts.
Do not tighten bolts at this time.
B - Installation using inline or remote
blowers - with ducting through front
panel opening
CAUTION
If fl exible blower is mounted as an inline blower: Do
not use legs alone for support. It may be necessary to
add extra support for the fl exible blower.
1. Remove hex nuts to remove front panel cover.
2. If blower discharge is down, remove (4) #8-32 hex nuts
and electrical panel.
3. Place 6" or 8" (152mm or 203mm) round rough-in plate
(purchase separately) over studs around front panel
opening.
4. Tighten hex nuts to secure remote discharge plate in place.
(4) BOLTS
English 15