Safety Messages To Installers And Users - Federal Signal Global Serie G-SND Sounder Instalación Y Instrucciones De Mantenimiento

Safety Messages to Installers and Users

It is important to follow all instructions shipped with this product. This sounder
is to be installed by a trained electrician who is thoroughly familiar with and will
follow all applicable national and local codes in the country of use.
This sounder should be considered a part of the warning system and not the
entire warning system.
The selection of the mounting location for the sounder, its controls and the
routing of the wiring are to be accomplished under the direction of the facilities
engineer and the safety engineer. In addition, listed below are some other
important safety instructions and precautions you should follow:
• Read and understand all instructions before installing or operating this
equipment.
• To avoid electrical shock hazards, do not connect wires when power is
applied. Failure to observe this warning may lead to serious injury or death.
• Never alter the unit in any manner. Safety in hazardous locations may be
endangered if additional openings or other alterations are made in units
specifically designed for use in these locations.
• Do not connect this sounder to the system when power is on.
• All effective warning sounders produce loud sounds, which may cause, in
certain situations, permanent hearing loss. Take appropriate precautions
such as hearing protection. The device should be installed far enough away
from potential listeners to limit their exposure while still maintaining its
effectiveness.
• After installation, ensure that all threaded joints are properly tightened.
• After installation, test the sounder system to ensure that it is operating
properly
• Keep the unit tightly closed when in operation.
• After testing is complete, provide a copy of this instruction sheet to all
personnel.
• Brass inserts have the potential to store charge when they are not plugged.
Consideration should be taken to prevent these from becoming a sparking
hazard.
• Establish a procedure to routinely check the sounder system for proper
activation and operation.
• This equipment is suitable for use in Class I, Division 2, Groups A, B, C, D;
Class II, Division 2, Groups F and G; Class III or non-hazardous locations
only.
Installation and Maintenance Instructions
Model G-SND Global Series Sounder
5