Publicidad
Idiomas disponibles
Idiomas disponibles
20
Zettler Relay 2
Zettler Relay
Disconnection Detail
24. Cut off and discard the female spade terminal from
the wire that was connected to the Zettler relay. Strip
off the appropriate amount of wire insulation and install
wire (EE, Figure 21) into a 3 pin lever lock (FF, Figure
21, Ref. 10) from the kit contents.
21
FF
14
25. From the kit contents, locate and select they yellow 16
AWG wire (GG, Figure 22, Ref. 3). Cut the yellow 16
AWG wire in half, and strip the ends of the cut wires.
On each of the cut wires crimp a blue fork terminal
(HH, Figure 22, Ref. 8) on one of the ends.
22
GG
DD
26. Install the fork terminal end of each yellow wire (II,
Figure 19a-b) on DC post 2 of 725 light relay 1 and 2.
Then, install the bare wire ends of the two black wires
into the open ports of the 3 port lever lock (JJ, Figure
19a-b) that was installed in Step 20.
23a
I I
725 Relay 1
725 Relay 2
EE
HH
JJ
I I
www.allmand.com
Publicidad
