Allmand 725 Instrucciones De Instalación página 6

15. Install the fork terminal end of the black wire (P, Figure
11a-b) on DC post 1 of the 725 light relay. Then, install
the bare wire end of the black wire into one of the
open ports of the 3 port lever lock (Q, Figure 19a-b)
that was installed in Step 20.
16. On Zettler light relay 2 disconnect the remaining
16 AWG wire (R, Figure 19a&c) from the DC power
spade. This wire should be leading from the divider
panel of the component block. On Zettler relay 1
disconnect the 16 AWG wire from the same spade.
11a
P
Zettler Relay 2
11b
P
725 Relay
Connection Detail
6
R
Q
725 Relay
Q
725 Relay
11c
Zettler Relay 2
Zettler Relay
Disconnection Detail
17. Cut off and discard the female spade terminal from
the wire that was connected to the Zettler relay. Strip
off the appropriate amount of wire insulation and install
wire (S, Figure 21) into a 3 pin lever lock (T, Figure 21,
Ref. 10) from the kit contents.
12
T
R
S
www.allmand.com