Tools And Fasteners Needed - Levolor Sheer Shadings Instalación

GETTING STARTED
Product View
Single Headrail Shading
Limit
Stop
Headrail
End Cap
Magnetic
Hold-Down
Bracket
(Optional)
End Cap
Two-On-One Headrail Shading
Limit Stop
Headrail
End Cap
Cord Loop
4
Continuous Cord Loop Operating System
20-0034-033_Sheer_Shadings_Cont_Cordloop_F_010621.indd 4-5
Installation
Bracket
Headrail
Cord Loop
Tension
Device
Bottom
Rail
Installation
Bracket
Headrail
Cord Loop
Thank you for purchasing LEVOLOR Sheer Shadings. With proper installation,
®
operation, and care, your new shadings will provide years of beauty and performance.
Please thoroughly review this instruction booklet before beginning installation.

Tools and Fasteners Needed

•
Flat and Phillips head screwdrivers
•
Measuring tape and pencil
•
Power drill, / " drill bit,
3
32
and 1 / " hex driver
4
In addition, you will need fasteners designed to work with your specific mounting
surface(s).
•
#6 Hex Head Screws (Provided). Two 1
installation bracket.
•
Longer #6 Hex Head Screws (Not Provided). If using spacer blocks,
use #6 screws long enough for a secure attachment.
•
Speed Nuts and Screws (Provided). Extension brackets come with screws
and speed nuts.
•
Drywall Anchors (Not Provided). Use drywall anchors when mounting
into drywall.
Longer #6 Hex Head Screw
#6 x 1 1 / "
2
Hex Head Screw for Use with Spacer Blocks
(Provided) (Not Provided)
Importance of Limit Stops on Window Shadings
Limit stops serve as the upper travel limit for the bottom rail, preventing it from
rotating around the fabric roll. Limit stops are located 6" from the ends of the
headrail or are centered on shadings less than 36" wide.
When a shading is made, the limit stops are adjusted according to the size of the
fabric roll. Occasionally, this adjustment changes during shipping or installation.
If this happens, problems can be fixed by readjusting the limit stops. See page 16
in the Troubleshooting section if shading operation is difficult or if the bottom rail
rotates around the fabric roll. Shown below are the four possible positions of limit
stops for large to small fabric rolls.
Large Fabric Roll
GETTING STARTED
•
Level (laser level is recommended)
•
Pliers and/or scissors (heavy-duty)
/ " screws are provided per
1
2
Speed Nut
and Screw
(Two Provided with
Each Extension Bracket)
Small Fabric Roll
Continuous Cord Loop Operating System
1/6/21 4:47 PM
5