Mount The Installation Brackets - Side Mount; Install The Shading; Install The Tension Device - Levolor Sheer Shadings Instalación

INSTALLATION
•
If using spacer blocks:
— Stack spacer blocks on the backside of
the installation brackets,
— Using #6 Hex Head Screws long enough for
secure installation (not provided), install screws
through the installation bracket and spacer
blocks into mounting surface.
IMPORTANT: Do not add more than 1
of clearance using spacer blocks.
IMPORTANT: The tops of the installation
brackets must be level, with the front
edges aligned.
IMPORTANT: Use drywall anchors when
mounting into drywall.
•
If using extension brackets, attach an installation
bracket to the underside of each extension bracket
using the speed nuts and screws provided.
Proceed to "Install the Shading" on page 11.
SIDE MOUNT
Mount the Installation Brackets
Side mount the headrail when conventional mounting
techniques will not work — for example, in an arched
window opening.
•
Mount the extension brackets on a surface at
least 1 ⁄ " wide.
1
4
•
Attach the installation brackets to the extension brackets
using the provided screws and speed nuts.
CAUTION: When securing side mounted shadings into a surface other than
!
a secure wall stud, use medium to heavy-duty wall anchors (not provided).
Match anchors to the wall thickness. Failure to mount the brackets securely
may result in injury or property damage.
NOTE: Spacer blocks cannot be used with side mount installations.
Proceed to "Install the Shading" on page 11.
10
Continuous Cord Loop Operating System
20-0034-033_Sheer_Shadings_Cont_Cordloop_F_010621.indd 10-11
Longer
Screw
Spacer
Blocks
⁄ "
1
2
Speed Nuts
Screws
Extension
Bracket
1 / "
1
4
Minimum
Depth

Install the Shading

•
Position the shading so that
the front faces you.
•
Slide the headrail into the
installation brackets so the
edge of the headrail is between
the lever and the bracket, as shown.
•
Firmly push the headrail into each bracket until it clicks and the
lever snaps to the right side of the bracket.
IMPORTANT: Carefully pull on the headrail at each bracket to ensure it is
installed securely.

Install the Tension Device

IMPORTANT: Before you proceed, you must first slide
the cord tensioner to the bottom of the cord loop.
•
Insert a small screwdriver, punch, or awl through the
screw hole at the bottom of the cord tensioner.
•
Move the screw hole down to the indicator line to
release the safety mechanism.
•
Slide the cord tensioner down to the bottom of the
cord loop.
•
Attach the cord tensioner according to the instructions
provided with the Universal Cord Tensioner Installation Kit.
WARNING: It is imperative that the cord tensioner be properly secured
!
to the wall or window frame to reduce children's access to the cord loop.
Young children can strangle in cord loops. They can also wrap cords
around their necks and strangle.
CAUTION: The shading will not operate properly unless the cord tensioner
!
is secured. A universal Cord Tensioner Installation Kit has been included
with your shading. Follow the instructions in the kit to correctly secure the
cord tensioner.
INSTALLATION
Lever
Headrail
Installation
Bracket
Slide the Headrail
between the Lever
and the Bracket.
11
Continuous Cord Loop Operating System
1/6/21 4:47 PM