Safety Messages To Installers And Users - Federal Signal Electraflash 141ST-120 Instrucciones De Instalación Y Mantenimiento

Safety Messages to Installers and Users

It is important to follow all instructions shipped with this product.
This device is to be installed by a trained electrician who is
thoroughly familiar with the National Electrical Code and/or Canadian
Electrical Code and will follow the NEC and/or CEC Guidelines as
well as all local codes.
This device should be considered a part of the warning system and not
the entire warning system.
The selection of the mounting location for the device, its controls and
the routing of the wiring are to be accomplished under the direction
of the facilities engineer and the safety engineer. In addition, listed
below are some other important safety instructions and precautions
you should follow:
• Read and understand all instructions before installing or operating
this equipment.
• Do not connect this light to the system when power is on.
• Never alter the light in any manner. Safety may be affected
if additional openings or alterations are made to the internal
components or housing.
• After installation, test the light system to ensure that it is operating
properly.
• After testing is complete, provide a copy of these instructions to
all personnel.
• Establish a procedure to routinely check the light system for
proper activation and operation.
• Not to be used as a visual public mode alarm notification
appliance.
Failure to follow all safety precautions and instructions may result in
property damage, serious injury, or death.
Electraflash
Installation and Maintenance Instructions
Models 141ST-120 and 141ST-240
®
5