Translation of the original instructions
FLASHLIGHT FUNCTION
FAULT CODES (PRO 12 XL)
Reverse polarity
High current
PROBLEM SOLVING (PRO 24 XL)
Troubleshooting
The screen is black and shows nothing.
Each connection causes a flashing red and
green "8" to appear on the display.
A fixed red "8" appears on the LCD screen
when the clamps are connected and an
alarm sounds.
A fixed red "8" appears on the LCD screen
as soon as the booster switches on.
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
14
NOMAD POWER PRO 12 XL / 24 XL
Press the ON/OFF button on the LED (9) to activate the lighting.
Each new press changes the lighting mode (3 available modes: normal,
strobe light, SOS) until the light goes out.
Timed out
Low current
Causes
Sleep mode is on.
The booster doesn't detect a battery.
The device detects a polarity reversal.
Thermal protection of the booster.
Short circuit.
The battery is heavily discharged (<4V). Replace the vehicle battery.
High temperature
Short circuit
Solutions
Press the ON/OFF button or toggle the main
switch to the OFF then ON position. The
screen lights up again.
Turn on the lights or the radio so that the
NOMAD POWER detects a current load and
activates.
Check the battery polarity. Red clamp to the
positive battery terminal (+) and the black
clamp to the negative (-).
The charger is overheated because the am-
bient temperature is high. Wait a few minutes
for the booster to cool down before trying to
start again.
Damaged battery. Change the battery.
EN
Low temperature
Unit is not
activating