Troubleshooting - GYS NOMAD POWER PRO 45 Manual De Instrucciones

60"
6b
7
CHARGING MOBILE PHONES
FLASHLIGHT FUNCTION
PROTECTIONS
This device is protected against short-circuits, polarity reversals and use under non-recommended temperatures (reminder: optimum
working condition -20°C / +40 °C).
TROUBLESHOOTING, CAUSES, REMEDIES

TROUBLESHOOTING

No response while pressing the ON/
1
OFF button
2 Impossible to start the vehicule.
8
NOMAD POWER PRO 45
If the booster clamps are connected to the correct polarity, but LED indicators are not
flashing. The voltage of vehicle's battery might be too low, so the base unit could not
identify the polarity. Please press and hold the Jump start button (2) for 5 seconds to
activate the jump start function FORCIBLY.
When all the LED indicators are flashing, please start the engine within 60 seconds.
The jump function will be shut down automatically after 60 seconds.
When the engine has been started successfully, please press the power button (1) for
5 seconds to switch off the jump starter. Remove the booster cable clamps from the
vehicle's terminal.
Connect the USB plug (not supplied) to the USB socket and press the power
button (1) to activate the unit to start charging your electronic device (mobile
or tablet).
not supplied
When power is on, press the button
Briefly press the button
normal, flash, SOS and OFF).
CAUSES
The NOMAD POWER PRO is discharged.
Vehicle battery level is too low.
Vehicle battery is out of order.
Engine size is too big
- Petrol engine : 3500 cm3 max
- Diesel engine : 2000 cm3 max
Short-circuit
to turn on the LED.
to switch lighting modes (4 available modes:
REMEDIES
Charge the product (see page 6).
Force the start (see step 6b).
Change the vehicle battery
-
Check that the clamps are connected properly (see step 4).
EN