Troubleshooting - GYS GYSPACK 750 Manual De Instrucciones

TROUBLESHOOTING

Anomalies
Alarm beep and the booster red LED
lights.
The booster red LED flashes.
Sparks appear when putting the
clamps on the battery.
The device doesn't start the vehicle.
The Booster red LED flashes.
The device cannot start the vehicle
and the booster red LED is off.
BATTERY NOT COVERED BY WARRANTY
Batteries are live parts, their useable life depends on how they are maintened. After each use of this device, it is
essential to recharge the internal batteries. Storage in places with high temperatures greatly reduces the battery charge.
In the case of prolonged non-use, it is strongly recommended to recharge the batteries before use. In general, we
recommend leaving the product plugged in continuously to maintain the batteries at their best performance.
This product is equipped with a high performance battery if the maintenance instructions are not followed the batteries
can deteriorate irreversibly over time.
For this reason the GYSPACK 750 batteries are excluded from the warranty.
GYSPACK 750
Causes
The polarity has been reversed.
The battery voltage has dropped
below 12.5V after starting or a high
consumption of energy.
The switch is on 12V position.
The polarity has been reversed.
The battery in the device is
discharged.
Several start attempts without
pausing.
The internal battery voltage is too
low. It might be damaged.
The fuse has melted.
Remedies
Check the battery polarity.
Charge the device after use. The red
LED flashes at least for 15 minutes
before shutting down.
Before connecting the clamps to the
battery switch the knob to the OFF
position.
Check the battery polarity.
Charge the device fully and try again.
Wait 3 minutes between each start
attempts. Starting must not exceed 5
seconds.
Charge the device trying to restore
the battery.
Check and replace the fuse
EN
7