Technical Data - Riello RS5F Instrucciones De Instalación, Montaje Y Funcionamiento

LPG KIT
There is a special kit available that, when mounted on the combustion head, enables burners designed to
run off natural gas to burn LPG instead.
Refer to the instructions supplied with the "LPG kit" for installation.
The kit must be installed in conformity with laws and local regulations.
SEAL CONTROL KIT
There is a special kit available that can be used to check the seal of the gas train's valve.
The kit must be installed in conformity with laws and local regulations.
2.

TECHNICAL DATA

2.1 TECHNICAL DATA
TYPE
Thermal power (1)
Natural gas (Family 2)
Electrical supply
Motor
Capacitor
Ignition transformer
Absorbed electrical power
(1) Reference conditions: Temperature 20°C - Barometric pressure 1013 mbar – Altitude 0 m above sea level.
Natural gas supply (Family 2) for the various countries:
COUNTRY
GAS CATEGORY
G20 H
GAS
G25 L
PRESSURE
G20 E
NOTE:
For burners running off LPG (Family 3), it is advisable to order a specific kit separately.
20094559
Net heat value: 8
~
50Hz 220/230 V
Run current 1.9 A
2720 rpm
Primary 230V - 0.2A
AT - IT - DK - CH GB - IE
II2H3B/P II2H3P
–
20
25
–
–
–
920 T1
−
160 330 kW -
137,600
−
12 kWh/Nm
Pressure: min. 20 mbar
Single phase,
±
10%
- 288 rad/s
8 µF
– Secondary 8 kV - 12 mA
0.43 kW
DE FR
II2ELL3B/P II2Er3P
– –
20 –
20 20 / 25
3 GB
−
283,800 kcal/h
−
3
= 7000 10,340 kcal/Nm
- max. 100 mbar
Single phase,
~
60Hz 220/230 V
Run current 2.3 A
3320 rpm - 347 rad/s
0.60 kW
NL LU
II2L3B/P II2E3B/P
– –
25 25
– –
3
±
10%
BE
I2E(R)B, I3P
–
–
20 / 25