Parker Controller Family Manual De Uso página 104

Settings in the Options Program oP
Options program
oP
Password entry
PAS
0000 = no password
Example password 1234 = 1234
Setting the unit of measurement:
uni
mm/inch = measurement of the level in mm or inch beginning
with the bottom edge of the sensor (oFFS = 0) or the bottom of
the tank.
% = displays the level in percent.
Therefore, the level displayed does not depend on the size of
the tank.
The display range percentage is determined by SEt0 and SEt1
(refer to point SEt0 and SEt1).
Display: value shown on the digital display during run mode.
diS
Act = actual level
SP1 = switching point 1
SP2 = switching point 2
OFF = off indication
Min = minimum level
MA = maximum level
The offset value indicates the range between the bottom of the
oFFS
tank and the lower edge of the sensor. Therefore the display
and the switching point show the actual fill level.
Not activated if unit = %
Reset if unit = %
104