Parker Controller Family Manual De Uso página 93

Error displays
The set value is lower than the other respective parameters.
Att1
Press Enter
rSP and froM, to).
Zero point calibration error!!
Att2
The value which should be set as the zero point is greater than
5% of the measuring range end value.
Device electronics defective. Please send in for repair.
Err1
Nominal device pressure / measuring range exceeded by 10%.
Err2
Please check system pressure!
Nominal device pressure / measuring range has been ex-
Err3
ceeded. Analogue electronics defective.
Please check system pressure!
If error persists, please send device in for repair.
to adjust the smaller value (see menu point SP,
9