Error Function; Delay Times (0 To 9.99 Sec.) For The Pressure And Temperature Switch - Parker Controller Family Manual De Uso

10.

Error function

Switching output 2 can optionally be used for error output purposes to
indicate functional switch errors. As an error output it is normally closed.
When there are errors (Err1, Err2, Err3) it is open and the LED II is illu-
minated. The display and the error output remain active until the error is
cleared. (Refer to menu option Err.)
This conforms to DESINA when used with a 4-pole M12x1 con-
nection plug.
10.4 Delay times (0 to 9.99 sec.) for the pressure and tempera-
ture switch
Setting delay times make it possible to filter out unwanted short-term or
high-frequency measurement peaks (attenuation).
In order for the switch to actuate, the measurement value must exist for
this amount of time. The controlled state is not altered immediately when
the switching event is reached, but only after the delay time has elapsed.
If the switching event is no longer in existence after the delay time has
elapsed, the switching output does not change. (Refer to menu options
dSP and drS.)
11