Honeywell Miller MIGHTEVAC Instrucciones Para El Usuario página 10

Fig. 1
5.3 INSTALLATION PROCEDURE TO TRIPOD (REF. FIG. 2A AND 2B)
Step 1: Place bracket hook over adjustment pin.
Step 2: Rotate bracket toward Tripod leg until the top holes of the bracket pass the Tripod leg and
insert pin completely through both sides of the bracket. (NOTE: This pin will pass behind the Tri-
pod leg, not through it--see Fig. 2b.)
Step 3: Align the bottom holes in the bracket with holes in the Tripod leg and insert pin through
bracket and Tripod leg. Be sure the pin is completely through both the bracket and Tripod leg.
To remove the device, simply reverse the installation procedure.
WARNING: Be careful not to remove the pin that collapses the Tripod leg, as serious injury may
occur.
Fig. 2b
Fig. 2a
10