Publicidad
Idiomas disponibles
Idiomas disponibles
MC-5451330-Bedien-0909.qxd
process carefully and, if necessary,
stop early and finish the process with
an ordinary screwdriver. Always
practise first!
• Starting:
Press the ON/OFF switch (3): The
screwing process will start. Press and
keep the switch during the screwing
process.
• Stopping:
As soon as the screw has been screwed
in or removed fully, release the On/Off
switch.
Rechargeable battery charge display (9)
The charged state of the battery can be
checked using the battery charge
display (9). To do this, press button (a)
on the battery charge display.
The charged state is displayed on the
display (b) in 5 segments.
All 5 segments are lit: The battery is
fully charged (100%).
The discharge status is displayed in
20% steps (where 1 segment is 20%).
When there is only one segment (20%)
lit, the battery has almost discharged
and will need to be charged soon.
10 – Mode of operation
Electronic rotation speed regulation
Using the electronic rotation speed
regulation (3), you can adapt the rotation
speed continuously to the respective job.
64
11.09.2009 16:34 Uhr
• Light pressure on the switch (3) = low
• Switch pressed hard = highest
loading when boring or screw-driving!
Clockwise/anti-clockwise run
You determine the rotation direction with
the aid of the slide switch (4) above the
operating switch.
stopped!
• Screw-driving in bolts: Slide switch to
• Turning off bolts: Slide switch to
• Safety position: Switch middle
Seite 64
rotation speed, in order to loosen
stuck bolts.
possible rotation speed, for boring.
CAUTION! Avoid the motor
coming to a standstill under
PLEASE NOTE! Change rotation
direction only with motor
Position R.
Position L.
position; in this position of the slide
switch the device cannot be put into
operation, e.g. in case of work
breaks, bit or drill change.
Publicidad
Capítulos
