Shenzhen Sonoff Technologies Co.,Ltd.
4. Power on
After powering on, the device will enter the pairing mode during the first use and the
LED signal indicator flashes.
The device will exit the pairing mode if no next operation for a long time. If enter again,
please long press the manual switch for 5s until the LED signal indicator flashes and
release.
5. Add sub-devices
Connect the Bridge before adding the sub-device.
Access eWeLink APP, select the Bridge that you want to connect, and tap "Add" to add
a sub-device, and be patient until pairing completes.
If the addition failed, move the sub-device closer to the Bridge and try again.
SONOFF ZigBee Bridge supports connecting
multiple sub-devices at the same time.
Power the Bridge on, set the sub-device to the pairing mode. Then access the Bridge
page in the eWeLink APP to tap "Add", and be patient until the pairing completes.
N In
N In
L In
L In
N In
ZBBridge
Added:0
No child device,please add.
Add
ZBBridge
Added:0
No child device,please add.
Add
LOut
S1
S2
Add Device
Connecting
Keep the device close
enough to the hub.
>
35s
Looking for device
1 devices Found
Add Device
Connecting
Keep the device close
enough to the hub.
>
25s
Looking for device
3 devices Found
6