Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Step 4: Install the Axle/Drive Shaft
a. Slide the Drive shaft through one side of the
hopper frame
b. Slide gearbox onto axle/drive shaft (make sure
"FRONT" is facing front of frame as shown) and
align middle hole with gearbox
c. Slide through the other side of the hopper
frame. Assemble M5 x 35mm Hex bolt to Axle/
Gearbox and secure with M5 Nylon Locknut.
M5 x 35mm Hex bolt
Step 5:
Attach non-drive Wheel onto exposed end of Axle and secure with Flat Washer & Cotter Pin. Slide
the Flat Washer onto the Axle until it makes contact with the Wheel, and then slide the Cotter Pin
into the hole at the end of the Axle.
Additional Notes:
Drive Shaft: Hole Near Middle should be closer to the right wheel so that the gear box is centered.
Bend
CHAPIN INTERNATIONAL, INC. P.O. BOX 549 700 ELLICOTT ST. BATAVIA, NY 14021-0549 www.chapinmfg.com 800-950-4458
Publicidad
Tabla de contenido
