Chapin 82125 Operación Instrucciones página 6

Step 9:
Attach Edge Control cable. Turn spreader upside down for step 9 (if possible set on table as shown) Note: While doing
this make sure the Edge Control lever is in the ON position and the trim guard itself is making contact with the bottom of
the hopper base. Slide the Wire onto the hole on the wire control barrel (Fig. A). Pull wire through barrel until it is taute.
Tighten the Set screw onto the wire with aPhillips head screw driver. Next take a P-clamp and place it on the cable sheath.
Align so P-clamp is under mount post. Take a self tapping screw and screw the P-clamp into the hole on the bottom of the
hopper base (Fig. B & C). The wire should be tight so the trim guard doesn't fall when released.
Figure B
CHAPIN INTERNATIONAL, INC. P.O. BOX 549 700 ELLICOTT ST. BATAVIA, NY 14021-0549 www.chapinmfg.com 800-950-4458
Cable Sheath
Table
Wire Control
Barrel
Figure A
Figure C
Trim Guard
Tighten