Publicidad
Idiomas disponibles
Idiomas disponibles
3 YEARS
L I M I T E D WA R R A N T Y
CUTTING DISC REPLACEMENT
1. Replace the cutting disc
Disconnect the plug from the power source before replacing the cutting disc to prevent possible accidents (machi-
ne cuts).
1
2
3
5
4
6
(1) Lower the bar (1) with your left hand to insert the washer wheel (2) into the slot. Look at it and then loosen the
screw with the wrench (5).
(2) Untie screw and washer (4) and washer wheel (3) one by one, then remove cutting disc (6).
2. Install the Cutting Disc
(1) Clean the disassembled screws and washers from the dust. To install them, check the procedure mentioned
above, but in reverse (4).
(2) After tying the screw and the washer, check to see the bar (1) that it has been reassembled and properly.
2
4
7
1
6
Llave
Wrench
5
3
7
Publicidad
